Version 2/14/2014 INSTALLATION, OPERATION & MAINTENANCE MANUAL XP-SKX SERIES - (PUMP END ONLY) EXPLOSION PROOF SUBMERSIBLE SHREDDER PUMPS (CLAS
10 More frequent inspections are required if the pump is used in a harsh environment. Preventative maintenance should be perf
11 EXPLODED VIEW OF XP-SKX15CSS (2HP) BJM STAINLESS STEEL WET END ASSEMBLY FOR EIM FM MOTOR
12 EXPLODED VIEW OF XP-SKX22CSS, XP-SKX37CSS (3 & 5HP) BJM STAINLESS STEEL WET END ASSEMBLY FOR EIM FM MOTOR
13 EXPLODED VIEW OF XP-SKX55CSS, XP-SKX75CSS BJM STAINLESS STEEL WET END ASSEMBLY FOR EIM FM MOTOR
14 EXPLODED VIEW OF XP-SKX110CSS, XP-SKX150CSS BJM STAINLESS STEEL WET END ASSEMBLY FOR EIM FM MOTOR
15 XP-SKX PARTS LIST Pump Model XP-SKX15CSS XP-SKX22CSS XP-SKX37CSS XP-SKX55CSS XP-SKX75CSS XP-SKX110CSS XP-SKX150CSSPos. No. Part Descri
16 XP-SKX DIMENSIONAL DRAWING
17 SEAL MINDER® - THERMAL MOTOR SENSOR SWITCH Seal Minder: Also known as a seal failure circuit (or moisture detection circuit) is designed to inf
18
19
20 BJM PUMPS, LLC BJM PUMPS, LLC 123 Spencer Plain Road Old Saybrook, CT 06475, U.S.A. WARRANTY AND LIMITATION OF LIABILITY Unless otherwise
START-UP REPORT FORM START-UP REPORT FORM This form is designed to record the initial installation, and to serve as a guide for troubleshooting at a
START-UP REPORT FORM Are guide rails vertical? Yes No Is base elbow installed level? Yes No Liquid level controls: Model Is control installed
START-UP REPORT FORM L1-L2 L2-L3 L3-L1 Amperage load connection, pump on L1 L2 L3 FINAL CHECK Is pump secured properly? Yes No Was pump checked f
NOTES:
BJM Pumps is a registered trademark of BJM Pumps, LLC. Copyright © 2009-2013 BJM Pumps, LLC. All rights reserved.
28
29
31
TABLE OF CONTENTS INTRODUCTION ...
32
33
34
35
EIM ELECTRIC CO., LTD.36
37BJM MODEL: XP-SK15
38BJM MODEL: XP-SK22
39BJM MODEL: XP-SK37
40BJM MODEL: XP-SK55
41BJM MODEL: XP-SK75
4 INTRODUCTION This Installation, Operation and Maintenance manual located in the front half of this manual only covers the pump end (we
42BJM MODEL: XP-SK110
43BJM MODEL: XP-SK150
5 Hazards or unsafe practices that COULD result in severe personal injury or death. These instructions describe the procedure required, and the i
6 Lifting: Attach a rope or lifting chain (not included) to the handle (or lifting rings) on the top of the pump. Do not lift the pump by the p
7 Do not run pump dry. Pump liquid should not exceed a maximum temperature of 104°F. Never place the pump on loose or soft ground. The p
8 Two ways to check the correct pump rotation: 1. By looking at the impeller; the rotation of the impeller should be counter clockwise as shown i
9 Consult EIM ELELCTRIC Co., LTD. Instruction Manual for Installation, Operation and Maintenance before connecting, operating or conducting maintena
Commentaires sur ces manuels