Version 2/3/2014 INSTALLATION, OPERATION & MAINTENANCE MANUAL SK & SKX SERIES SHREDDER PUMPS Electric Submersible Pumps Single Phase 115
10 MANUAL OPERATION All SK & SKX Models are provided with a 33’ (10 m) power cord. NEVER splice the power cable due to safety and wa
11 STOPPING To stop the pump (manual and automatic mode), unplug it from the power source, turn off the breaker, or turn the power source off (gen
12 TYPICAL MUNICIPAL OR INDUSTRIAL WASTEWATER INSTALLATION NOTE: Maximum recommended starts should not exceed 10 times per hour. AUTOMATIC OPERAT
13 Typical 3 phase Auto Control 1 INTENDED METHODS OF CONNECTION Use with approved motor control that matches motor input in full load ampe
14 shock. DO NOT UNDER ANY CIRCUMSTANCES REMOVE THE GROUND PIN. The three prong plug must be inserted into a mating three prong grounded receptacl
15 Connect pump to a junction box, outlet box, control box, enclosure with a wiring compartment that meets NEC and local codes.
16 MAINTAINING YOUR PUMP Pump should be disconnected from the electric power supply before proceeding to do any service or maintenance. Pu
17 EXPLODED VIEW OF SK750C, SK1500C
18 EXPLODED VIEW OF SKX750CSS, SKX1500CSS
19 EXPLODED VIEW OF SK08C, SK15C
20 EXPLODED VIEW OF SKX08CSS, SKX15CSS
21 EXPLODED VIEW OF SK22C, SK37C
22 EXPLODED VIEW OF SKX22CSS, SKX37CSS
23 EXPLODED VIEW OF SK55C, SKX55CSS, SK75C, SKX75CSS
24 EXPLODED VIEW OF SK110C, SKX110CSS, SK150C, SKX150CSS
25 SK SERIES PARTS LIST Pump Model SK750C SK1500C SK08C SK15C SK22C SK37C SK55C SK75C SK110C SK150CPos. No. Part Description Item # Item # Item # I
26 27 Power Cable w/ Gland- 230V,1PH, No Plug 201694 201694 - - - - - - - -27 Power Cable w/ Gland- 3PH - - 201701 201701 203442 203444 203446 20344
27 SKX SERIES PARTS LIST Pump ModelSKX750CSS SKX1500CSS SKX08CSS SKX15CSS SKX22CSS SKX37CSS SKX55CSS SKX75CSS SKX110CSS SKX150CSSPos. No. Part Des
28 27-2 Oil Sensor Cable 201713 201713 201713 201713 201713 201713 201713 201713 201713 20171327-2-1 O-Ring Kit Only Kit Kit Kit Kit Kit Kit Kit Kit
29 SINGLE PHASE WIRING DIAGRAM 115V & 230V W/GOVERNOR SWITCH MODELS SK750C, SKX750CSS, SK1500C, SKX1500C
3 TABLE OF CONTENTS INTRODUCTION ...
30 THREE PHASE WIRING DIAGRAMS 208V MODELS SK08C, SKX08CSS, SK15C, SKX15CSS, SK22C, SKX22CSS, SK37C, SKX37CSS, SK55C, SKX55CSS,
31 230V MODELS SK08C, SKX08CSS, SK15C, SKX15CSS, SK22C, SKX22CSS, SK37C, SKX37CSS, SK55C, SKX55CSS, SKX75C, SKX75CSS, SK110C, SKX110CSS
32 460V MODELS SK08C, SKX08CSS, SK15C, SKX15CSS, SK22C, SKX22CSS, SK37C, SKX37CSS, SK55C, SKX55CSS, SKX75C, SKX75CSS, SK110C, SKX110CSS, SK150C, S
33 575V MODELS SK08C, SKX08CSS, SK15C, SKX15CSS, SK22C, SKX22CSS, SK37C, SKX37CSS, SK55C, SKX55CSS, SKX75C, SKX75CSS, SK110C, SKX110CSS, SK150C, SK
34 SEAL MINDER®
35
36 BJM PUMPS, LLC 123 Spencer Plain Road Old Saybrook, CT 06475, U.S.A. WARRANTY AND LIMITATION OF LIABILITY Unless otherwise expressly aut
START-UP REPORT FORM START-UP REPORT FORM This form is designed to record the initial installation, and to serve as a guide for troubleshooting at a
START-UP REPORT FORM Are guide rails vertical? Yes No Is base elbow installed level? Yes No Liquid level controls: Model Is control installed
START-UP REPORT FORM L1-L2 L2-L3 L3-L1 Amperage load connection, pump on L1 L2 L3 FINAL CHECK Is pump secured properly? Yes No Was pump checked f
4 INTRODUCTION This Installation, Operation and Maintenance manual provides important information on safety and the proper inspection, disas
NOTES:
BJM Pumps & Seal Minder is a registered trademark of BJM Pumps, LLC. Copyright © 2006-2013 BJM Pumps, LLC. All rights reserved.
5 Hazards or unsafe practices which COULD result in personal injury or product or property damage. These instructions describe the procedure req
6 Pumps and related equipment must be installed and operated according to all national, local and industry standards. INSPECTION Review
7 OIL FILL QUANTITY/TYPE OIL IN SEAL CHAMBER MODEL U.S. FL. OZ. CC. TYPE OF OIL SK750C 7.8 230 ISO 32 NSF Food Grade Mineral Oil SK750C-3 7.8 2
8 Risk of electric shock. Pump models; SK750C, SK750C-3, SKX750CSS & SK750CSS-3 (115v) are supplied with a grounding conduc
9 2. By looking from the top of the pump. Since the impeller cannot be seen, the best way to check the rotation is to check the kick back motio
Commentaires sur ces manuels